Pathway Pathport Manager 5 User Guide Manual do Utilizador descarregar pdf (Página 31)

Pathway Connectivity

Pathport Manager 5 v1 Manual

Base Node Property Definitions

Name Definition

Name Node name – user assignable

MAC Address Media Access Control address – factory assigned

IP Address Internet Protocol (IPv4) Address – editable

IP Subnet Mask IP subnet mask – editable

IP Default Gateway IP address of system router – not typically used

Firmware Version Current operating firmware number

Identify Node Enabling causes node to flash screen or LEDS

Node Serial Number Factory-assigned serial number

Enable Keypad Lockout Enable/Disable any front panel keys

Enable LCD Backlight Turns LCD screen backlight on or off

LED Intensity Uno only. Toggles between Bright and Dim

Universe Select Lockout Jumper

Uno and eDIN only. Reports if universe jumper is set,

and to what universe (1-4)

Enable IrDA Port Feature no longer supported in firmware

Receive Artnet Enable/disable Artnet

Receive E1.31 Streaming ACN Enable/disable sACN

Receive ETC Net2 Enable/disable ETC Net2 (one- and two-ports only)

Receive Pathport Protocol Enable/disable Pathport

Receive Shownet Enable/disable Shownet

Transmit Network Protocol

Select input protocol from drop down. Choices are

Artnet, Pathport, Shownet and streaming ACN.

ArtNet Alternate Mapping

Toggle between Artnet universe 0-0 shown as Univ 1 or

ignore Artnet universe 0-0 altogether

E1.31 Transmit Version Toggle between Draft 20 and ANSI Final Release

sACN Input Priority

Toggle between ignore sACN input priority schemes or

accepting sACN input priority (disables other protocols)

Has Terminal Blocks Informational

Is Rack Mounted Informational

ETCNet2 Admin Multicast

Address

Future use

ETCNet2 EDMX Multicast

Address

Future use

Bootp Deselect for static IP. Select to seek for Bootp server

Bootp Timeout (seconds)

# of seconds a node seeks for Bootp server before

completing boot up with last used IP address

Force Dynamic IP

Forces node to wait for IP address from DHCP or Bootp

server. Node will hang if no server present. Not

recommended for most installations

Do TFTP Upgrade

Forces node to wait for IP address from DHCP or Bootp

server, then request firmware file during boot up. Node

will hang if no server present, or server doesn’t have

firmware file. Not recommended for most installations.

Note: Pathport Manager 5 does not provide a Bootp or DHCP server.

1 2 ... 26 27 28 29 30 31 32 33

Comentários a estes Manuais

Sem comentários

Pathway Pathport Manager 5 User Guide Manual do Utilizador Página 31

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware de computador Pathway Pathport Manager 5 User Guide