Pathway #910x DMX Repeater Pro for firmware of 1.4.0 or hi Manual do Utilizador

DMX Repeater Pro User’s Guide Version 3.0 January 2008 For Firmware Versions 1.4.0 and higher Suite 103, 1439 - 17 Avenue S.E.

DMX Repeater Pro User’s Guide 10 The Console function sends a DMX level to all output ports, allowing an independent check on downstream or

DMX Repeater Pro User’s Guide 11 Port Status: The letters appearing below the Port indicate the port’s customization. Many combinations a

DMX Repeater Pro User’s Guide 12 RDM DISCOVERY The DMX Repeater Pro provides a straight-forward interface to discover and configure RDM-enab

DMX Repeater Pro User’s Guide 13 MORE ON DMX HUB MODE When hard-wiring a number of console input receptacles to a dimming or distribution s

DMX Repeater Pro User’s Guide 14 MORE ON DMX MERGER MODE Often an installation requires an architectural controller and a lighting console to be

DMX Repeater Pro User’s Guide 15 APPENDIX A – XLR CONNECTOR PINOUTS DMX512A 1 – Common 2 – Data – 3 – Data + 4 – Data 2 – (not used) 5 – Data 2 + (

DMX Repeater Pro User’s Guide 2 TABLE OF CONTENTS Overview ...

DMX Repeater Pro User’s Guide 3 OVERVIEW This manual describes the function and configuration options for the Pathway Connectivity DMX Repeater

DMX Repeater Pro User’s Guide 4 as an RDM device, as well as providing the functions of an in-line controller. Warning: Except for the

DMX Repeater Pro User’s Guide 5 DMX Status: The first display shows DMX activity and the number of current input channels detected. Some c

DMX Repeater Pro User’s Guide 6 Selecting a Personality To begin, press the Home button. The screen will read “Pathway DMX Repeater Pro”

DMX Repeater Pro User’s Guide 7 to them. If DMX signal is lost, the Repeater Pro will begin the scanning process all over again. This

DMX Repeater Pro User’s Guide 8 LCD Backlight. Use the up\down arrows to set the desired level of backlight and the check-mark to accept. The

DMX Repeater Pro User’s Guide 9 In DMX Hub mode, selecting a port forces the DMX Repeater Pro to switch signal sources, but only if DMX is active at