Pathway MR Installers Guide Manual do Utilizador

DMXPathfinder MR Installer’s Guide Version 1.2 February 2004. 480C - 36 Avenue S.E. Calgary, AB, T2G 1W4 Canada Phone: (403) 243-811

DMXPathfinder LR Installation & Assembly 9 Pin 1 -- Signal Common (shield) Pin 2 – DMX Data (-) Pin 3 – DMX Data (+) Pin 4 – Talkback Data (-) Pi

DMXPathfinder LR Installation & Assembly 10 Patching To assign outputs to inputs, first remove the front cover to access the Crosspoint Card (

DMXPathfinder LR Index 11 Chapter 2: Maintenance & Testing TESTING THE INSTALLATION Once all connections are made and inspected for possible erro

DMXPathfinder LR Index 12 To replace an Output Module card, first remove the four front-panel Phillips screws and the cover panel, then grasp the car

DMXPathfinder LR Index 13 The Fluke 650's signalling is not compatible with the DMXPathfinder MR electronics or any other DMX generating or rece

DMXPathfinder LR Index 14 and transmitter circuits. Next, a DMX tester should be used to either transmit DMX in place of the control console, or rece

DMXPathfinder LR Index 15 INDEX A Advanced Troubleshooting · 13 Ambient temperature · 3 Assembly · 3 B bus terminator · 7 C CABLE A IN · 7 CABLE A(

DMXPathfinder MR Contents 1 CONTENTS INTRODUCTION...

DMXPathfinder LR Introduction 2 INTRODUCTION WELCOME TO THE WORLD OF DMXPATHFINDER! This Installation Guide is intended to walk you through a typical

DMXPathfinder LR Installation & Assembly 3 Chapter 1: Installation and Assembly SUMMARY This section describes how to correctly assemble the DMX

DMXPathfinder LR Installation & Assembly 4 Power Requirements -- A single-phase power source (50 or 60Hz, 100-240VAC, at 0.2A per Input Module

DMXPathfinder LR Installation & Assembly 5 RACK SIZING AND PLACEMENT The system installer normally supplies the DMXPathfinder MR equipment rac

DMXPathfinder LR Installation & Assembly 6 One of two types of cable termination boards are normally supplied with the system to provide the phys

DMXPathfinder LR Installation & Assembly 7 MODULE PREPARATION Unpack all of the DMXPathfinder MR system modules and accessories and arrange on

DMXPathfinder LR Installation & Assembly 8 I/O CABLE CONNECTION Strip back about 3 inches (8cm) of cable jacket and braid shield from each in